TKS K2 - Page 61

TKS Operator's manual
61
26 Invalid
sequence line
cut
Line commands are
misspelled, and
the machine does not
understand it.
• Error in command line,
read Chap. 3.3.4
advanced sequence
• Enter the command again.
27 Filling -
emergency stop
Emergency stop button
is pressed on multifi ll
control box.
• An emergency stop
switch has been
pressed (or an external
emergency stop button
that is connected to
multifi ll control box).
• In the event of an emergency
stop, the working area of the
vehicle must be checked
• Release all emergency stop
switches - turn in the
direction of the arrow.
• Reset the alarm
28 Conveyor 1,2,
eller 3 Error
Conveyor fault, and
number
• There is no feedback
from the pulse sensor
on the roller shaft, or
it is set up wrongly in
setup fi lling sources.
• Check settings fi lling sources
in Chap. 3.9.2
• Check if there is input from
the sensor in Chap. 3.9.3
29 Adjustable
fi lling time has
been exceeded.
Adjustable fi lling time
has been exceeded.
• Maximum fi lling time is
exceeded.
• Check if the fi lling source is
empty or if the fi lling time is
set too short in Chap. 3.5.4
30 No weight is
registered
during fi lling.
No weight is registered
during fi lling.
• The fi lling source is
empty, or errors in
weight setup.
• If the fi lling source is not
empty, the weight system
must be checked, and the
31 Filling - overload Filling - overload • Check load quantity. • Check max level sensor.
32 Filling source
empty
Filling source empty • Maximum fi lling time
has been exceeded.
• Check if the fi lling source is
empty or if the fi lling time is
set too short in Chap. 3.5.4
33 Max feeding
time
Max feeding time
exceeded
• Check max load
feeding time
• Adjust the feeding time
Chap. 3.5.4, or check
photocell in the magazine.
34 Loading
cancelled due to
communication
problems
Loading
cancelled due to
communication
problems
• Faulty Wi-Fi between
control box and multifi ll
box.
• Check Wi-Fi connection
between EasyFeed and
multifi ll box.
Check if the multifi ll has
power.