Page 1-6 Document Ref 942583-001 Rev 8
Introduction Quantium 510 Installation Manual
1.5.5 PERSONAL PROTECTIVE EQUIPMENT (PPE)
PROTECTIVE CLOTHING
The following clothing should be worn at all times during installation and
maintenance procedures:-
•Protective helmet.
•Protective shoes (conductive).
•Protective gloves and/or protective hand cream.
•Anti static clothing.
•Eye protection.
SAFETY EQUIPMENT FOR WORKING IN HAZARDOUS AREAS
The following safety equipment is required for working in hazardous areas:-
•Only spark free tools are permitted for work on dispensers.
•Work on bearings is only permitted using the standard workshop tools authorised
for this kind of work.
•The use of all electrical tools is strictly prohibited.
•Only the use of explosion protected work lights is permitted.
•The use of telecommunications equipment in hazardous areas is strictly prohibited.
SAFETY INSTRUCTIONS
The following safety instructions must be adhered to during installation and
maintenance procedures:-
•Inhalation of petrol vapour must be avoided. Suitable precautions must be taken
and where necessary respirators used.
•Avoid direct contact of fuel with the skin.
•Use suitable protective clothing, protective gloves and/or protective hand cream.
•Avoid fuel spills.
•No smoking, no naked flames are permitted.
•Long hair and ties can get caught in moving parts. Hair must be suitably covered.
NOTE: - WHEN PRIMING A DISPENSER FROM EMPTY, ON UNITS
WITH AIR VENTS TO OUTSIDE OF FRAME, ENSURE THE NOZZLE
IS ON LOW FLOW FOR 2 - 3 MINUTES.
Do not drive away with
nozzle in tank
Visible from both
sides of dispenser
Next to User Instructions
near the nozzle boot
To Next Page
Loading...