Page 5-4 Document Ref 942583-001 Rev 8
Installation Quantium 510 Installation Manual
1) Unload the dispenser from the transport
truck and place it on even ground.
Remove the forklift truck and remove
the transport packaging.
2) Re-position the forklift into the
wooden transport pallet, raise and
move the dispenser close to its
forecourt position.
3) Lower the dispenser to about 20mm
off the ground. Use a 13mm spanner
or socket to loosen and remove the
two bolts holding the centre pallet
section to the driptray on the front of
the dispenser and remove it.
5.4.1 DISPENSER WITHOUT LIFTING SLOTS AND ON WOODEN
TRANSIT PALLET
To Next Page
Loading...