Tokheim Quantium 510 - INSTALLATION

To Next Page

To Previous Page

Document Ref 942583-001 Rev 8 Page 5-1

Quantium 510 Installation Manual Installation

SECTION 5 CONTENTS

5 INSTALLATION.......................................................................................................... 5-2

5.1 General .................................................................................................................5-2

5.2 Identification of Sides ...........................................................................................5-2

5.3 Lifting ...................................................................................................................5-3

5.4 Placement.............................................................................................................5-3

5.4.1 Dispenser Without Lifting Slots and on Wooden Transit Pallet ...........5-4

5.4.2 Dispenser Without Lifting Slots and on Metal Transport Profile .........5-7

5.4.3 Dispensers with lifting Slots or Brackets, Forklift pitch Chart...........5-10

5.4.4 Dispenser with LIfting Slots and on Wooden Transit Pallet ..............5-12

5.4.5 Dispenser with Lifting Slots and on Metal Transit Profile .................5-15

5.4.6 M-SAT Dispenser With Lifting Slots on Metal Profile

Transport Pallet..................................................................................5-18

5.4.7 Using Jacking Bolts to Lower a Dispenser .......................................5-21

5.4.8 Leak Plate Sealing .............................................................................5-22

5.4.9 Fixing to Ground.................................................................................5-23

5.4.10 Earthing..............................................................................................5-24

5.5 Hydraulic Connections .......................................................................................5-25

5.5.1 Installation of TQP-HS Pumps ..........................................................5-25

5.5.2 Pipework - Suction Dispensers..........................................................5-25

5.5.3 Fitting A risbridger Check Valve ........................................................5-27

5.5.4 Pipework - Submerged Dispensers ...................................................5-27

5.5.5 Pipework - VR ..................................................................................5-27

5.5.6 New Submerged Installation - Manufactured after January 2015 ....5-28

5.6 Electrical Connections........................................................................................5-30

5.6.1 Junction Box Wiring ...........................................................................5-31

5.6.2 Communications Wiring in Main Junction Box ..................................5-40

5.6.3 Special Dispenser Configurations ......................................................5-42

5.6.4 Media Head Configuration ................................................................5-44

5.6.5 Media Head Connections ..................................................................5-45

5.6.6 Panduit Connector Instructions..........................................................5-46