5-6
5.3.3 Maintenance of the main unit
Do not use organic solvents for cleaning the AL-100 as
they may cause damage to the surface.
When removing the power cord, grasp the plug, not the
cord and do not apply undue force.
Do not touch pins inside the connector.
Wipe off dirt gently with a wet cloth and then remove
excess water with a dry cloth. If dirt is difficult to re-
move, use a diluted, mild detergent.
Since touch panel LCD is weak in humidity, do not leave
it with water or other liquid on its surface. The surface
will be damaged and the panel can not be used.
Clean the surface of the monitor with a dry cloth. If dirt
is difficult to remove, use diluted, mild detergent on a
soft cloth. Then rinse and remove excess moisture with
a dry cloth.
While the unit is used, put dust cover to avoid dust.
When the unit is not used for a certain period of time,
unplug the power cord.
To Next Page
Loading...
Need help?
General
