1-1
1 PRIOR TO USE
1.1 Precautions for use
Make sure that this Instrument must be installed in a
place without any intensive electromagnetic wave or the
wave generating devices. An intensive electromagnetic
field causes noises to interrupt the Instrument from func-
tioning proper diagnosis and measurement.
Nothing must be put on this unit.
Read this Operator manual carefully before using the in-
strument in order to operate it properly and safely.
Do not use any procedures that are not specified in the
manual.
Only well-trained personnel should operate this instrument.
When installing this instrument, observe the following:
- Do not install the instrument in a place where it might be exposed to
moisture or chemicals.
- Do not install the instrument in a place where it is subject to adverse
condition, such as direct sunlight, high temparature, excessive humidity,
dust, sulfur or salt.
- Ascertain that any adverse factors such as excessive slope, vibration and
impact will not endanger the instrument (including during
transportation).
- Do not install the instrument in or near the storage area of chemical
substances or where any gas may be generated.
- Follow frequency, voltage and allowable current (or allowable power
consumption) specifications.
- Be cautious of electrical power condition such as discharge, polarity, etc.
- Connect the grounding properly, which may otherwise cause an electric
shock.
To Next Page
Loading...
Need help?
General
