1-2
Before using this instrument, observe the following:
- Ascertain that all cables and cords are properly connected.
- Carefully inspect the probe tip before using.
- Ascertain that the power source is properly grounded.
- When using this instrument with other unit, be careful not to cause any
inaccurate diagnosis or danger.
- Check if there is no crack or rash on the probe tip before it is applied to the
patient.
While using this instrument, observe the following:
- Always make sure that the patient is comfortable.
- Always make sure that both instrument and patient are under normal
condition.
- If any complication or abnormality is encountered, either with the patient
or instrument, ensure the safety of the patient by discontinuing testing.
- Make sure that patient has no contact with the instrument (other than the
probe) during testing.
After using this instrument, observe the following:
-
Make sure that the unit is the same condition as initial, before turnning off the
unit.
(See 3.9 Shut Down, page 3-80)
- When disconnecting the power cord, hold the plug, not the cord, and do
not use excessive force.
- Be sure to clean the probe and other accessaries after each use.
- If you do not plan to use the instrument for a considerable period of time,
refer to Section 5.5 for storage instructions.
- Be sure to clean the instrument to prepare for next use.
In case of a malfunction, do not attempt to repair the instrument yourself.
Place a sign on the instrument indicating that it is malfunctioning and
contact your Tomey representative.
Do not technically modify this instrument.
Please be informed that the instrument should be inspected regularly.
When using the instrument, which has not been used for a certain period of
time, make sure that the instrument works normally and safely, before using.
To Next Page
Loading...
Need help?
General
