Tonghui TH2827 Series - Page 3

TH2827 Series Operation Manual Contents
III
3.5 <MEASURE SETUP> ............................................................. 24
3.5.1 Trigger mode ............................................................ 25
3.5.2 Auto level control function .......................................... 26
3.5.3 Bias current isolation function ..................................... 26
3.5.4 Average ................................................................... 27
3.5.5 Level monitor function ............................................... 27
3.5.6 Delay time ............................................................... 28
3.5.7 Output impedance .................................................... 28
3.5.8 Deviation test function ............................................... 29
3.6 <CORRECTION> .................................................................. 30
3.6.1 OPEN ...................................................................... 31
3.6.2 SHORT .................................................................... 33
3.6.3 LOAD ...................................................................... 34
3.6.4 Load correction test function ...................................... 35
3.6.5 Cable length selection ............................................... 36
3.7 <LIMIT TABLE> ................................................................... 36
3.7.1 Swap parameter ....................................................... 37
3.7.2 Limit modes of compare function ................................ 37
3.7.3 Set nominal value of tolerance mode ........................... 39
3.7.4 Comparator function ON/OFF ...................................... 39
3.7.5 Auxiliary bin ON/OFF ................................................. 39
3.7.6 HIGH/LOW ............................................................... 40
3.8 <LIST SWEEP SETUP> ......................................................... 41
3.8.1 MODE ..................................................................... 42
3.8.2 Test parameter ......................................................... 42
3.8.3 Sweep parameter setup ............................................. 42
Chapter 4 [SYSTEM] and <FILE MANAGE> ............................................. 44
4.1 <SYSTEM SETUP> ............................................................... 44
4.1.1 PASS BEEP ............................................................... 44
4.1.2 FAIL BEEP ................................................................ 45
4.1.3 LANGUAGE .............................................................. 45
4.1.4 PASS WORD ............................................................. 45
4.1.5 BUS MODE (Reserved function) ................................... 46
4.1.6 GPIB ADDR (Reserved function) .................................. 46
4.1.7 TALK ONLY ............................................................... 46
4.1.8 BIAS SRC ................................................................ 47
4.1.9 BAUD RATE .............................................................. 47
4.1.10 DATA/TIME .............................................................. 47
4.2 LCR <FILE MANAGE> ........................................................... 47
4.2.1 Setup file for single-group component (*.STA) .............. 48
4.2.2 U-disk manage performance ....................................... 49
4.2.3 Operation steps for file management ........................... 49
Chapter 5 Execute LCR operation and some examples ............................. 52
5.1 Correction operation ............................................................. 52