Tonghui TH2827 Series - Correction Subsystem Commands

TH2827 Series Operation Manual Chapter 7 Command Reference
99
7.1.14 CORRection subsystem commands
The CORRection subsystem commands are mainly used to set the correction
function, OPEN, SHORT, LOAD.
Command tree:
CORRection :LENGth <value>
:METHod SINGle
MULTiple
:OPEN :STATe ON (1)
OFF (0)
:SHORt :STATe ON (1)
OFF (0)
:LOAD :STATe ON (1)
OFF (0)
:TYPE CPD
CPQ
CPG
CPRP
CSD
CSQ
CSRS
LPQ
LPD
LPG
LPRP
LSD
LSQ
LSRS
RX
ZTD
ZTR
GB
YTD
YTR
:SPOT1 :STATe ON (1)
2 OFF (0)
3 :FREQuency <value>
:OPEN
:SHORt
:LOAD :STANdard <REF.A>,<REF.B>
:USE :DATA?
:CLEAR