Tonghui TH2827 Series - Function Subsystem Commands

TH2827 Series Operation Manual Chapter 7 Command Reference
87
7.1.9 FUNCtion subsystem commands
The FUNCtion subsystem commands are mainly used to set measurement
functions, range, current/voltage monitor ON/OFF, deviation display mode,
nominal setting.
Command tree:
FUNCtion :IMPedance CPD
CPQ
CPG
CPRP
CSD
CSQ
CSRS
LPQ
LPD
LPG
LPRP
LSD
LSQ
LSRS
RX
ZTD
ZTR
GB
YTD
YTR
DCR
:RANGe <value>
:AUTO ON (1)
OFF (0)
:Source MONitor :VAC ON (1)
OFF (0)
:IAC ON (1)
OFF (0)
:DEV1 :MODE ABSolute
2 PERcent
OFF
:REFerence <value>
:FILL
The FUNCtion:IMPedance command is used to set instrument functions. The