Tonghui TH2827 Series - BIAS Subsystem Commands

TH2827 Series Operation Manual Chapter 7 Command Reference
85
The :DC:ISOLation command is used to set the DC isolation function of the
100mA/10V DC bias source as ON or OFF. The :DC:ISOLation? query returns the
current status of the DC isolation function.
Command syntax:
ON
OUTPut:DC:ISOLation OFF
1
0
Where,
Character 1 (49) is equal to ON.
Character 0 (48) is equal to OFF.
Query syntax: OUTPut:DC:ISOLation?
Return format: <NR1><NL^END>
7.1.8 BIAS subsystem commands
The :BIAS subsystem commands are mainly used to set the internal bias voltage
and the bias status.
Command tree:
BIAS :STATe ON (1)
OFF (0)
:VOLTage <value>
MIN
MAX
:CURRent <value>
MIN
MAX
The BIAS:STATe command is used to set the bias status. The :STATe? query
returns the current bias status.
Command syntax:
ON
BIAS:STATe OFF
1
0