TH2827 Series Operation Manual Chapter 7 Command Reference
82
<LIST SWEEP MEAS> The current page is the list sweep display page.
<MEAS SETUP> The current page is the measurement setup page.
<CORRECTION> The current page is the correction page.
<LIMIT TABLE SETUP> The current page is the limit table setup page.
<LIST SWEEP SETUP> The current page is the list sweep setup page.
<SYSTEM SETUP> The current page is the system setup page.
<FILE LIST> The current page is the file list page.
The :LINE command is used to set the current measurement item which can be a
substring with up to 16 characters. The :LINE? query returns the current
measurement item. The character string of the measurement item can be used as
the file name when saving a file.
Command syntax: DISPlay:LINE”<string>”
Where,
<string> can be an ASCII character string (maximum number is 16).
For example: WrtCmd(“DISP:LINE” Resistor meas””)
Query syntax: DISPlay:LINE?
Return format: <string><NL^END>
The :ResultFONt command is used to set the current font of the measurement
result. The :ResultFONt? Query returns the current font of the measurement
result.
Command syntax: DISPlay:RFONt <font>
<font> can be the following information:
LARGe: Use large character to display the measurement result, 12ms/meas.
TINY: Use tiny character to display the measurement result, 5ms/meas.
OFF: Measurement result will not be displayed but can be read from the bus.
Query syntax: DISPlay:FRONt?
Return format: <font><NL^END>
<font> can be the following information:
LARGE
TINY
OFF
7.1.2 FREQuency subsystem commands
The FREQuency subsystem commands are mainly used to set the measurement
frequency of the instrument. The :FREQuency query returns the current
measurement frequency.
<value>
Command syntax: FREQuency MIN
MAX
To Next Page
Loading...
