Topcon HiPer Ga - Page 44

Pre-survey Preparation
HiPer Ga/Gb Operator’s Manual
2-10
3. Select the Power Mode drop-down list to set the power source
(Figure 2-7). Current Mode displays the current power source.
• Auto – receiver automatically selects the power source
• Mix – receiver automatically detects and consumes power
from the source with the largest voltage
• Battery A – receiver consumes power from battery A
• Battery B – receiver consumes power from battery B
• External – receiver uses an external power supply
Figure 2-7. Select Power Mode
4. Select the Charger Mode drop-down list to set the charger mode
(Figure 2-8 on page 2-11). Current Mode displays the charging
battery: a, b, or none (off).
• Off – receiver will not charge batteries
• Charge A – receiver charges only battery A
• Charge B – receiver charges only battery B
• Auto – receiver automatically detects and charges both
batteries