Topcon HiPer Ga - Page 54

Pre-survey Preparation
HiPer Ga/Gb Operator’s Manual
2-20
The security section allows you to set data security and
unauthorized access parameters for the Bluetooth module.
7. Enter up to 14 characters to set a unique name for the Bluetooth
module (Figure 7).
8. To set security parameters (Figure 2-16 on page 2-20), enter and
enable the following, then click Apply:
• Bluetooth PIN – enter up to 16 characters to specify a
personal identification number for the Bluetooth module.
• Encryption – enable to have the Bluetooth module encrypt
wirelessly sent data. To read encrypted data, the user must
have the same PIN used in the device that sent the data.
• Authentication – enable to require a PIN before two
Bluetooth enabled devices (such as, the receiver and a
computer) can establish a communication link. The two
devices must use the same PIN.
Figure 2-16. BTCONF Security Parameters
9. Click the Serial Interface tab (Figure 2-17). Enable Echo to
display Bluetooth module replies and corresponding commands
on the computer terminal. Click Apply.
NOTICE
If you do not need security settings, leave these
parameters disabled.