Maintenance
Motorgrader System Five Operator’s Manual
6-8
3. Now remove the shoulder screw, washer, and jam nut from the
Rotation Sensor arm.
Figure 6-8.
4. Carefully lift the Rotation Sensor from its base plate.
Figure 6-9.
NOTICE
NOTICE
DO NOT force or pry the Rotation Sensor from the base
plate. The Rotation Sensor pin may bend or break.
5. Use a clean rag and thoroughly clean the base plate and bottom of
the Rotation Sensor.
REMOVE
SHOULDER SCREW,
WASHER, AND
JAM NUT FROM
"L"-BRACKET
GENTLY LIFT ROTATION SENSOR
FROM BASE PLATE AND
WIPE SURFACES CLEAN
To Next Page
Loading...
