Topcon Motorgrader - Slope Control Sensor Details

Slope Control
P/N 7010-0344
2-33
Slope Control
System Five uses 3 sensors to measure and cut the desired slope
perpendicular to the edge of the road.
• Blade Slope Sensor
A blade slope sensor is mounted to the back of the circle. It
contains an electronic level vial, which acts as a precision
carpenters level. As the blade is raised or lowered, the Blade
Slope Sensor continuously measures the slope of the cutting edge
and sends the slope information to the Control Box.
Figure 2-40.
0.0
F
T
CONTROL MODE
G A INSS E T/ + / — /T R IMM E NU
0.0%
+
0.0
F
T
CONTROL MODE
G A INSS E T/ + / — /T R IMM E NU
2.0%
+
0.0
F
T
CONTROL MODE
G A INSS E T/ + / — /T R IMM E NU
+
2.0%
S onic T racker II
S onic T racker II
S
onic
T
ra
cker
II
S
onic
T
rac
ker
II
S
o
n
i
c
T
r
a
c
k
e
r
I
I
S
o
n
i
c
T
r
a
c
k
e
r
I
I