Adjust Valve Offsets
P/N 7010-0344
3-11
Manual Adjusment
If the operator wants to make an adjustment or just verify that the
Valve Offset Values are correct, a "Manual" Valve Offset Calibration
can be performed.
1. Press the "Raise" button on the left hand side. Rotate left hand
knob, raising or lowering the Raise Offsets.
2. Press the "Lower" button on the left hand side. Rotate left hand
knob, raising or lowering the Lower Offsets until the left hand
side of the blade raises slowly.
3. Repeat on the right hand side for both the Raise and Lower
Offsets.
4. Press the "ENTER" button and the values will be saved.
NOTICE
NOTICE
Pressing "EXIT" does not save values.
Figure 3-13.
System
Five
System
Five
A
u
t
o
A
u
t
o
CONTROL MODE
G
a
in
s
S
E
T/+/
—
/T
R
IMM
E
NU
0.0% 0.0
F
T
+
BLADE WEAR CAL. (TRIM)
TURN AROUND AND STOP
OVER PREVIOUS PASS. IN
AUTO CHECK IF CUTTING
EDGE MATCHES.
2.0%
E
NT
E
R
E
XIT
ADJUST VALVE OFFSETS
E
NT
E
R
E
XIT
R
A
IS
E
L
OW
E
R
A
UTO
O
FF
S
E
TS
R
A
IS
E
L
OW
E
R
301 304
LEFT
303 265
RIGHT
To Next Page
Loading...
