Getting Ready to Grade
Motorgrader System Five Operator’s Manual
4-16
1. Setting the reference number to a known elevation:
This is typically used for jobs with flat, or dead level surfaces. For
example, if the cutting edge is at a known sea level elevation of
325.65 feet for example, then set the display to read 5.65 feet. In
this case, the operator can just dial in a desired elevation. This is
great when cutting multiple pads at different elevations.
Push the "SET" button, turn the knob to read 5.65 feet, the push
"ENTER".
Figure 4-24.
System
Five
System
Five
A
u
t
o
A
u
t
o
CONTROL MODE
G
a
in
s
+
/
—
M
E
NU
0.0% 0.0
F
T
+
2.0%
CONTROL MODE
G
A
INS
+
/
—
M
E
NU
2.0%
CONTROL MODE
G
A
INS
+
/
—
M
E
NU
5.65
F
T
CONTROL MODE
E
NT
E
R
Z
E
R
O
E
XIT
0.0%
+
To Next Page
Loading...
