Starting the Engine
Important: Y ou may need to bleed the fuel
system when starting a new machine, the engine
no longer runs due to lack of fuel, or you have
replaced or serviced the fuel system components.
1. Raise the roll bar and secure it into place.
2. Sit on the seat and fasten the seat belt.
3. Ensure that the parking brake is set and the
PT O switch is in the O FF position.
4. Remove your foot from traction pedal and
ensure that it is in neutral.
5. Rotate the key switch to the O N /P REHEAT
position.
Note: An automatic timer then controls the
preheat for a few seconds.
6. After preheating, rotate the key switch to the
S TART position, crank the engine for no longer
than 15 seconds , and release the key when
the engine starts.
Note: If additional preheating is required,
turn the key to the O FF position, then to the
O N /P REHEAT position. Repeat this process as
required.
7. Move the throttle to idle speed or partial throttle
and run the engine until it warms up.
Important: When you start the engine for
the rst time; or after you change the engine
oil, hydraulic uid, overhaul the engine, or
replace traction components; operate the
machine in forward and reverse for 1 to 2
minutes. Also, operate the lift lever and PT O
switch to ensure that all parts are properly
operating. T urn the power-steering wheel
to the left and right to check the steering
response. Then shut the engine off, check
the uid levels, and check for oil leaks, loose
parts, and any other malfunctions.
Shutting Off the Engine
CAUTION
T o prevent personal injury , shut the engine off
and wait for all moving parts to stop before
checking for oil leaks, loose parts, or other
malfunctions.
1. Move the throttle control rearward to the S LOW
position.
2. Move the PT O switch to the O FF position.
3. Rotate key switch to the O FF position. Remove
key from the switch to prevent accidental
starting.
Note: If the engine stops running and the key switch
is in the O N /P REHEAT position, and you leave the
operator's seat, after a short delay a buzzer will sound
to alert you to turn the key to the O FF position.
Engaging the Parking Brake
Pull the brake lever up and over to the left to engage
the brake.
g432821
Figure 22
Disengaging the Parking
Brake
Pull the brake lever up and over to the right and lower
the lever to disengage the brake.
31
To Next Page