Toro ProLine H600 - Lubricating the Driveshaft U-Joints

• Hopper pivots and steering pivot points ( Figure 44 )
g432493
Figure 44
• Hopper cylinder pivot and rear-axle pivot ( Figure
45 )
g432497
Figure 45
Lubricating the Driveshaft
U-Joints
Service Interval : Every 200 hours —Lubricate the
driveshaft U-joints.
Grease specication: No. 2 lithium grease
Important: Dusty and dirty operating conditions
could cause dirt to get into the bearings and
bushings, resulting in accelerated wear .
Note: Lubricate the grease ttings immediately after
every washing, regardless of interval specied.
1. Wipe grease tting clean so debris is not forced
into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe of f excess grease.
4. Remove the bolt and open the forward shield.
• Forward U-joint of the driveshaft at the mower
gearbox ( Figure 46 ).
g432465
Figure 46
• Rear U-joint of the driveshaft at the PT O ( Figure
47 ).
g434998
Figure 47
45