Toro ProLine H600 - Page 84

Problem
Possible Cause Corrective Action
1. The engine-oil pressure is insuf cient. 1. Check the engine-oil level and ll it, if
necessary .
The engine-oil warning light illuminates.
2. The engine-oil pressure is insuf cient. 2. Change the engine oil and engine-oil
lter .
1. The operator is not in the seat.
1. Sit in the operator ’ s seat.
The cutting unit does not run when the
PT O switch is engaged.
2. The hopper is not in the fully lowered
position.
2. Lower the hopper completely .
84