Decal Part: 121-3623
s_decal121-3623
Warning—read the Operator's Manual; do not
operate the machine unless you have received
training.
Warning—read the Operator's Manual before
towing the machine.
Tipping hazard—slow the machine before turning;
when driving on slopes, keep the cutting units
lowered and your seatbelt fastened.
Warning—do not park on slopes; engage the
parking brake, stop the cutting units, lower the
attachments, shut off the engine, and remove the
key from the ignition before leaving the machine.
Thrown object hazard—keep bystanders away.
Warning—wear hearing protection.
Entanglement hazard—keep away from moving
parts; keep all guards and shields in place.
Decal Part: 121-3628
s_decal121-3628
Tipping hazard—do not drive
across slopes greater than 25°.
Note: This machine complies with the industry standard stability test in the static lateral and
longitudinal tests with the maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the Operator’s Manual as well as the
conditions in which you would operate the machine to determine whether you can operate
the machine in the conditions on that day and at that site. Changes in the terrain can result
in a change in slope operation for the machine. If possible, keep the cutting units lowered to
the ground while operating the machine on slopes. Raising the cutting units while operating
on slopes can cause the machine to become unstable.
3466-297A Page 2–10 Safety: Safety and Instructional Decals
To Next Page
Loading...
