Chapter 6
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Note: Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and
searching for your machine from the Manuals link on the home page.
IMPORTANT
Refer to your engine owner’s manual and cutting unit Operator's Manual for
additional maintenance procedures.
Recommended Maintenance Schedule
Maintenance
Service Interval
Maintenance Procedure Part No.
Qty Description
After the first hour
Torque the wheel nuts.
- - -
After the first 10
hours
Torque the wheel nuts.
- - -
Check the condition and tension
of all belts.
130-1241 1 Alternator/fan belt
95-8730 1
Hydrostat drive belt
After the first 50
hours
Change the engine oil and the
engine-oil filter.
127-0511 1
Engine-oil filter
121-6395 1
15W-40 Premium Engine Oil (5
gallons)
121-6394 1
15W-40 Premium Engine Oil (55
gallons)
Before each use or
daily
Inspect the seat belt(s).
- - -
Check the interlock switches. - - -
Check the engine-oil level.
121-6395 1
15W-40 Premium Engine Oil (5
gallons)
121-6394 1
15W-40 Premium Engine Oil (55
gallons)
Drain the water separator.
- - -
Check the tire pressure.
- - -
Check the engine-coolant level.
- - -
Clean the engine cooling
system.
- - -
3466-297 A Page 6–1 Maintenance
To Next Page
Loading...
