Changing the Hydraulic Filter
WARNING
Hot hydraulic fluid can cause severe burns, which could result in death or serious
injury.
Allow the hydraulic fluid to cool before performing any maintenance to the hydraulic
system.
Use a genuine Toro replacement filter (Part No. 86-3010).
IMPORTANT
Use of any other filter may void the warranty on some components.
1. Prepare the machine for maintenance.
G417015
2. Clean around the filter mounting area .
Place a drain pan under the filter
and
remove the filter.
3. Lubricate the new filter gasket and fill the filter
with hydraulic fluid.
4. Ensure that the filter mounting area is clean.
Screw the filter on until the gasket contacts the
mounting plate; then tighten the filter 1/2 turn.
5. Start the engine and let it run for about 2
minutes to purge air from the system. Shut off the engine and check for leaks.
Cutting Unit Maintenance
Checking the Reel-to-Bedknife Contact
Check the reel-to-bedknife contact even if the quality of cut had been acceptable previously.
Note: There must be light contact across the full length of the reel and bedknife.
3466-297A Page 6–33 Maintenance: Hydraulic System Maintenance
To Next Page
Loading...
