Backlapping the Cutting Units (continued)
IMPORTANT
If you do not change backlap lever to the F (mow) position after backlapping, the
cutting units will not function properly.
G417036
Backlap lever
Reel speed control knob
4. Install the console cover to the control console.
5. Wash all lapping compound off from the cutting units.
6. For a better cutting edge, run a file across the front face of the bedknife after lapping.
Note: This removes any burrs or rough edges that may have built up on the cutting
edge.
Chassis Maintenance
Inspecting the Seat Belt
1. Inspect the seat belt for wear, cuts, and other damage. Replace the seat belt(s) if any
component does not operate properly.
2. Clean the seat belt as necessary.
Cleaning
Washing the Machine
Wash the machine as needed using water alone or with a mild detergent. You may use a rag
when washing the machine.
Maintenance: Chassis Maintenance Page 6–36 3466-297 A
To Next Page
Loading...
