IMPORTANT
The cable must not contact the battery cover.
6. Install the negative cable (black)
to the negative (–) battery terminal of the battery,
and secure them with T-bolt and nut.
WARNING
Incorrectly routing the battery cable could damage the machine and cables, causing
sparks. Sparks can cause the battery gasses to explode, which could result in death
or serious injury.
• Always disconnect the negative (black) battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery cable before connecting the negative
(black) cable.
IMPORTANT
If you ever remove the battery, ensure that the battery clamp bolts are installed with
the bolt heads positioned on the bottom side and the nuts on the top side. If the
clamp bolts are reversed, they may interfere with the hydraulic tubes when you shift
the cutting units.
7. Coat both battery connections with Grafo 112X skin-over grease (Toro Part No. 505-47)
or light grease to prevent corrosion.
8. Slide the rubber boot over the positive terminal to prevent a possible short from
occurring.
9. Install the battery cover.
4
Checking the Slope Indicator
Parts Required
1 Angle indicator (handheld)
1. Park the machine on a flat surface.
G402558
2. Verify that the machine is level by placing the
handheld angle indicator
on the frame cross
rail
.
3. If the handheld angle indicator does not read
0°, move the machine to a location where you
can attain a 0° reading.
3466-297A Page 3–4 Setup: Checking the Slope Indicator
To Next Page
Loading...
