8
Installing the Cutting Units
G402579
1. Slide a thrust washer onto each lift-arm
pivot rod.
2. Slide the cutting-unit-carrier frame
onto the
pivot rod and secure it with a lynch pin
.
Note: On rear cutting units, position the thrust
washer between the rear of the carrier frame
and the lynch pin.
3. Grease all lift arm and carrier frame pivot
points.
IMPORTANT
Ensure that the hoses are free of twists or sharp bends and that the rear cutting unit
hoses are routed as shown. Raise the cutting units and shift them to the left (Model
03171). The rear cutting unit hoses must not contact the traction cable bracket.
Reposition the fittings and/or hoses if necessary.
G402580
G402581
4. Route a tipper chain up through the slot on
the end of each carrier frame. Secure the
tipper chain to the top of the carrier frame with
a bolt, a washer, and a locknut.
Setup: Installing the Cutting Units Page 3–11 3466-297 A
To Next Page
Loading...
