G402560
4. Check the slope indicator mounted on the
steering tube of the machine.
Note: The slope indicator should read 0°
when viewed from the operator’s position.
5. If the slope indicator does not read 0°, loosen
the hardware securing the angle indicator to
the mounting bracket, adjust the indicator to
attain a 0° reading, and tighten the hardware.
5
Installing the Roll Bar
Parts Required
1 Roll-bar assembly
4 Flange-head bolt
4 Locknut
1 Hose clamp
WARNING
Operating the machine with a modified or damaged roll bar may not adequately
protect you in a rollover, which could result in death or serious injury.
• Do not install a damaged or modified roll bar on the machine.
• Replace a damaged roll bar; do not repair or alter it.
G402561
1. Lower the roll bar onto the traction unit
mounting brackets
, aligning the mounting
holes. Ensure that the vent tube
is on the
left side of the machine.
2. Secure each side of the roll bar to the
mounting brackets with 2 flange head bolts
and 2 locknuts. Torque the hardware to 81 N∙m
(60 ft-lb).
3. Secure the fuel-line-vent hose
to the vent tube with the hose clamp .
CAUTION
Starting the engine with the fuel-line-vent hose disconnected from the vent tube will
cause fuel to flow from the hose, increasing the risk of fire or explosion. A fire or
explosion from fuel could result in death or serious injury.
Connect the fuel-line-vent hose to the vent tube before starting the engine.
Setup: Installing the Roll Bar Page 3–5 3466-297 A
To Next Page
Loading...
