12
Installing the Hood Latch
CE Machines
Parts Required
1 Hood-latch bracket
2 Rivet
1 Washer
1 Screw (1/4 x 2 inches)
1 Locknut (1/4 inch)
1. Unhook the hood latch from the hood-latch bracket.
G402590
2. Remove the 2 rivets and the hood-latch
bracket
from the hood.
G402591
3. While aligning the mounting holes, position the
CE latch bracket
and the hood-latch bracket
onto the hood.
Note: The latch bracket must be against the
hood.
Do not remove the bolt and nut assembly
from the latch-bracket arm.
4. Align the washers with the holes on the inside
of the hood.
5. Rivet the brackets and the washers to the hood.
G402592
6. Hook the latch onto the hood-latch bracket
3466-297A Page 3–16 Setup: Installing the Hood Latch
To Next Page
Loading...
