Assembling the Carrier Frames for the Front Cutting
Units (continued)
G402575
1. Align the holes in the plates of the front-carrier
frame with the holes in the cutting unit
mounting plates.
Note: If you are starting assembly at the back
of the cutting unit, use the middle hole of the
plate.
2. Assemble the cutting unit to the rear carrier
frame as shown.
3. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
4. Repeat this procedure for the other front
cutting unit and carrier frame.
Assembling the Cutting Unit and Rear Carrier Frame
Cutting Unit with Links
Note: The rear carrier frame is part of the optional lift arm kit.
G402576
1. Align the hole in the plates of the rear-carrier
frame with the hole in the cutting unit mounting
plates.
Note: If you are starting assembly at the back
of the cutting unit, use the middle hole of the
plate.
2. Assemble the cutting unit to the rear carrier
frame as shown.
3. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
Assembling the Carrier Frames for the Front Cutting
Units
Cutting Unit with Mounting Plates
Note: The front carrier frames are part of the optional lift arm kit.
Setup: Installing the Carrier Frames to the Cutting Units Page 3–9 3466-297 A
To Next Page
Loading...
