Driving the Machine in Transport Mode
G402852
1. Move the cutting-unit-drive switch to the
D
ISENGAGE position.
2. Raise the cutting units to the transport position.
3. Move the mow/transport slide
left to the
T
RANSPORT position.
IMPORTANT
Be careful when driving between objects so that you do not accidentally damage the
machine or the cutting units. Use extra care when operating the machine on slopes.
Drive slowly and avoid sharp turns on slopes to prevent rollovers.
Note: You cannot lower the cutting units while operating the machine the transport mode.
3466-297A Page 5–7 Operation: During Operation
To Next Page
Loading...
