Checking Lift Arm and Rear Cutting Unit Clearance
(continued)
IMPORTANT
A lack of clearance at the front plate bracket could damage the lift arms.
G402585
3. At the rear cutting unit, measure the clearance
between the wear strap on the top of the rear
cutting unit wear bar
and the bumper stop
.
Note: The correct clearance is 0.51 to 2.54
mm (0.02 to 0.10 inch)
. If the clearance is
not in this range, adjust the cutting unit lift
cylinder.
IMPORTANT
A lack of clearance at the rear wear bar could damage the cutting unit.
4. Start the engine, lower the cutting units, shut off the engine, remove the key, and wait for
all moving parts to stop.
Adjusting the Lift-Arm Clearance
G402586
1. At each side of the machine, loosen the jam
nuts
and back off the lift arm-stop bolts .
Setup: Adjusting the Lift Arms Page 3–13 3466-297 A
To Next Page
Loading...
