Toro Reelmaster 3100-D - Pre-Maintenance Procedures; Preparing for Maintenance; Lifting the Front of the Machine; Lifting the Back of the Machine (Using a Hoist)

Pre-Maintenance Procedures
Preparing for Maintenance
1. Park the machine on a level surface, lower the cutting units, and engage the parking
brake.
2. Shut off the engine, remove the key, wait for all moving parts to stop, and allow the
engine to cool.
Lifting the Front of the Machine
1. Chock the tires.
G414298
2. Jack the front of the machine under the square
tube
of the lower frame as closely to the
side plate
as possible.
3. Support the machine with jack stands rated for
the weight of the machine under the square
tube or wheel motors.
Lifting the Back of the Machine (Using a Hoist)
G414299
1. Chock the tires.
2. Secure the hoist to the tie-down loop
of the
rear-wheel fork
.
3. Carefully raise the machine.
4. Support the machine with jack stands rated for
the weight of the machine under the frame
.
3466-297A Page 6–5 Maintenance: Pre-Maintenance Procedures