Toro Reelmaster 3100-D - Applying the Year of Production Decal and CE Decal; Applying the CE Tilt Danger Decal; Installing the Tipper Roller Kit (Optional)

Applying the Year of Production Decal and CE Decal
G411007
1. Wipe the left frame, near the model/serial plate
, with alcohol and allow the frame to dry.
2. Remove the backing and apply the Year of
Production decal
to the frame near the
serial plate.
G402596
3. Wipe the left frame, near the hood lock , with
alcohol and allow the frame to dry.
4. Remove the backing and apply the CE decal
to the frame.
Applying the CE Tilt Danger Decal
G402597
1. Wipe the tilt decal on the slope indicator
with alcohol and allow the decal to dry.
2. Remove the backing and apply the CE tilt
danger decal
as shown.
15
Installing the Tipper Roller Kit (Optional)
Parts Required
1 Tipper roller kit (not included)
When cutting in higher heights of cut, install the Tipper Roller Kit.
1. Raise the cutting units.
3466-297A Page 3–18 Setup: Installing the CE Decals