Assembling the Lift Cylinder to the Right Lift Arm
(continued)
IMPORTANT
Some hydraulic fluid is forced out at the hose fittings when you move the lift-cylinder
rod.
5. Assemble the rod to the flanges with the mounting pin
, 2 spacers , and 2 snap
rings
.
6. Apply No. 2 lithium grease to the grease fittings
of the lift arm and the hydraulic
cylinder.
G402574
7. Torque the swivel fittings of the return and
lift hoses
to 37 to 45 N∙m (27 to 33 ft-lb).
8. Clean hydraulic fluid from the machine.
7
Installing the Carrier Frames to the Cutting
Units
Parts Required
3 Cutting Unit (optional part—order separately)
Preparing the Cutting Units
1. Remove the cutting units from the cartons.
2. Adjust the cutting units as instructed in the Operator’s Manual for the cutting units.
Assembling the Carrier Frames for the Front Cutting
Units
Cutting Unit with Links
Note: The front carrier frames are part of the optional lift arm kit.
3466-297A Page 3–8 Setup: Installing the Carrier Frames to the Cutting Units
To Next Page
Loading...
