Cutting Grass with the Machine (continued)
6. Raise the cutting units off the ground using the cutting-unit-shift lever.
7. Once you reach the edge of the mowing area to start mowing, lower the cutting units
using the cutting-unit-shift lever.
Note: Practice to ensure the cutting units do not lower early or mow an unintended
area.
8. Complete the mowing pass.
9. When nearing the opposite edge of the fairway (prior to reaching the edge of the
mowing area), pull back the cutting-unit shift lever only long enough to raise the cutting
units, and release the lever.
IMPORTANT
Do not hold the cutting-unit shift lever back while turning.
10. Perform a tear-shaped turn to quickly line up for your next pass.
Side-Shifting the Cutting Units
Model 03171
G402857
1. Use the cutting-unit-shift lever to raise the
cutting units.
2. Move the cutting-unit-shift lever
left or right
to move the cutting units left or right.
3. Use the cutting-unit-shift lever to lower the
cutting units to the ground.
Operation: During Operation Page 5–6 3466-297 A
To Next Page
Loading...
