Starting the Engine (continued)
3. Move the throttle lever to the 1/2 throttle position.
4. Insert the key into the switch and rotate it to the O
N/PREHEAT position until the glow plug
indicator light shuts off (approximately 7 seconds); then rotate the key to the S
TART
position to engage the starter motor. Release the key when the engine starts.
Note: The key moves automatically to the ON/RUN position.
IMPORTANT
To prevent overheating of the starter motor, do not engage the starter longer than 15
seconds. After 10 seconds of continuous cranking, wait 60 seconds before engaging
the starter motor again.
5. When the engine is started for the first time or after an overhaul of the engine, operate
the machine in forward and reverse for 1 to 2 minutes. Also operate the lift lever and
cutting-unit-drive switch to ensure proper operation of all parts.
Note: Turn the steering wheel to the left and right to check the steering response, then
shut the engine off and check for oil leaks, loose parts, and any other wear or damage.
CAUTION
Checking for oil leaks, loose parts, and other malfunctions could result in minor or
moderate injury.
Shut off the engine and wait for all moving parts to stop before checking for oil leaks,
loose parts, and other malfunctions.
Shutting Off the Engine
1. Move the throttle control to the IDLE position.
2. Engage the parking brake.
3. Move the cutting-unit-drive switch to the D
ISENGAGE position.
4. Lower the cutting units.
5. Shut off the engine, remove the key, and wait for all moving parts to stop.
Cutting Grass with the Machine
1. Drive the machine to the mowing area and align the machine outside the cutting area for
the first cutting pass.
2. Press the cutting-unit-drive switch to the D
ISENGAGE position.
3. Move the throttle to the F
AST position.
4. Lower the cutting units completely using the cutting-unit-shift lever.
5. Press the cutting-unit-drive switch to the E
NGAGE position.
3466-297A Page 5–5 Operation: During Operation
To Next Page
Loading...
