Mower Manifold (continued)
G465040
Backlap control
Reel speed control
Reel Speed Knob
Use the reel speed knob of the mower manifold to adjust the clip rate (reel speed) of the
cutting units.
Turn the reel speed knob counterclockwise to increase the reel speed; turn the knob
clockwise to slow the reel speed.
Refer to Clip Rate (Reel Speed), page 5–8 and Adjusting the Reel Speed, page 5–9 for
information on how to adjust the reel speed control.
Backlap Control
The backlap lever controls the direction the cutting units rotate when you are mowing or
when you backlap the reels and bedknives.
Rotate the backlap lever to the F position when mowing; rotate the lever to the R position
when backlapping the cutting units.
Note: Do not change the backlap lever position while the reels are rotating.
Fuel Gauge
G465051
Product Overview: Controls Page 4–6 3466-297 A
To Next Page
Loading...
