Toro reelmaster 5410 series - Installing the Hydraulic Hose and Tube (O-Ring Face Seal Fitting)

InstallingtheHydraulicHoseandTube(O-RingFaceSealFitting)
1.Ensurethatallthethreads,thesealingsurfacesofthehose/tube,andthe
ttingarefreeofburrs,nicks,scratches,orunwantedmaterial.
2.Tohelppreventahydraulicleak,replacethefacesealO-ringwhenyouopen
theconnection.EnsurethattheO-ringisinstalledandcorrectlyseatedinthe
grooveofthetting.LightlylubricatetheO-ringwithcleanhydraulicuid.
g221221
Figure58
1.Tubeorhose
3.O-ring
2.Swivelnut
4.Fittingbody
3.Alignthehose/tubeagainstthebodyofthettingsothattheatfaceofthe
hose/tubesleevefullytouchestheO-ringinthetting(Figure58).
4.Useyourhandtothreadtheswivelnutontothetting.Whileyouholdthe
hose/tubeinalignmentwithawrench,useatorquewrenchtotightenthe
swivelnuttotherecommendedtorquevaluewithinthespeciedrangeof
torquevalues;refertotheHose/TubeInstallationTorqueT able(page6–12).
Thisproceduretotightentheswivelnutrequiresadrive-adapterwrench
(e.g.,crowfootwrench).
Note:Itmaybenecessarytouseadrive-adapterwrench(e.g.,crowfoot
wrench)toinstallahydraulictting;refertoCalculatingtheT orqueValues
WhenUsingaDrive-AdapterWrench(page2–6).
g221222
Figure59
1.Marknutandttingbody
3.Initialposition
2.Finalposition4.Extendline
5.Ifatorquewrenchisnotavailableorifspaceattheswivelnutpreventsthe
useofatorquewrench,usethealternativeprocedureFlatsFromWrench
Resistance(FFWR)givenbelow(Figure59).
A.Useawrenchtotightentheswivelnutontothettinguntilyoufeellight
resistancewiththewrench—approximately3.39N∙m(30in-lb).
B.Putamarkontheswivelnutandbodyofthetting.Holdthehose/tubein
alignmentwithawrenchtopreventthehose/tubefromturning.
Reelmaster
®
5410/5510/5610Series
Page6–11
HydraulicSystem:GeneralInformation
15216SLRevC