Toro reelmaster 5410 series - Cutting Reel Motor

CuttingReelMotor
g216668
Figure171
Reelmaster5510/5610seriescuttingreelmotors
1.#5hydraulicreelmotor6.O-ring
11.Hydraulichose16.Hydraulichose
2.O-ring7.Hydraulictting12.#3hydraulicreelmotor
17.Hydraulichose
3.90°hydraulictting8.O-ring13.#2hydraulicreelmotor
18.Hydraulichose
4.O-ring
9.Hydraulichose
14.#4hydraulicreelmotor19.90°hydraulictting
5.Hydraulichose10.Hydraulichose
15.Hydraulictting20.#1hydraulicreelmotor
Note:Sauer-DanfosscuttingreelmotorsareusedonReelmaster
5410/5410-G/5410-Dmachineswithserialnumbersbelow313999999.
CasappacuttingreelmotorsareusedonReelmaster5410/5410-G/5410-D
machineswithserialnumbersabove313999999andalsoReelmaster
5510/5510-G/5510-D/5610/5610-Dmachines.
RemovingtheCuttingReelMotor
1.Parkthemachineonalevelsurface,lowerthecuttingunits,shutoffthe
engine,settheparkingbrake,andremovethekeyfromthekeyswitch.
2.ReadtheGeneralPrecautionsforRemovingandInstallingtheHydraulic
SystemComponents(page6–145).
HydraulicSystem:ServiceandRepairs
Page6–202
Reelmaster
®
5410/5510/5610Series
15216SLRevC