Toro reelmaster 5410 series - Crosstrax AWD Control Manifold Assembly

CrossTrax™AWDControlManifoldAssembly
g186174
Figure161
1.Hydraulichose(4each)
6.Hydraulictube
11.O-ring(2each)
2.Straighttting(7each)7.O-ring(7each)
12.Framebracket
3.AWDcontrolmanifold8.O-ring(7each)13.Bolt(3each)
4.Hydraulictube
9.Dustcap(2each)14.Lockwasher(3each)
5.Hydraulictube
10.Diagnostictting(2each)15.Spacer(3each)
RemovingtheCrossTraxAWDControlManifoldAssembly
1.Parkthemachineonalevelsurface,lowerthecuttingunits,shutoffthe
engine,settheparkingbrake,andremovethekeyfromthekeyswitch.
CAUTION
Beforeopeningthehydraulicsystem,operateallthehydraulic
controlstoreleasesystempressureandavoidinjuryfromthe
pressurizedhydraulicuid;refertoReleasingPressurefromthe
HydraulicSystem(page6–8).
2.ReadtheGeneralPrecautionsforRemovingandInstallingtheHydraulic
SystemComponents(page6–145).
3.LocatetheCrossTraxAWDcontrolmanifoldthatisattachedtothebracket
atrearoftheframe.
4.Forassemblypurposes,labelallthehydraulicconnections.Cleanthe
hydraulicconnectionsbeforelooseningthehydrauliclines.
Reelmaster
®
5410/5510/5610Series
Page6–185
HydraulicSystem:ServiceandRepairs
15216SLRevC