Toro reelmaster 5410 series - Lift Control Manifold

LiftControlManifold
g216666
Figure167
1.Hydraulichose
9.O-ring17.Flange-headscrew(2each)
2.O-ring(6each)
10.Hydraulichose18.Hydraulichose
3.O-ring(2each)11.O-ring
19.Hydraulichose
4.Hydraulictube
12.90°hydraulictting
20.Hydraulichose
5.Hydraulictube
13.O-ring
21.Hydraulichose
6.O-ring(2each)14.Diagnostictting22.O-ring
7.45°hydraulictting
15.Dustcap
8.Hydraulichose
16.Liftcontrolmanifold
Note:Fortestingthesolenoidvalvecoils;refertoTestingtheHydraulicSolenoid
ValveCoils(page7–96).
RemovingtheLiftControlManifold
1.Parkthemachineonalevelsurface,lowerthecuttingunits,shutoffthe
engine,settheparkingbrake,andremovethekeyfromthekeyswitch.
2.ReadtheGeneralPrecautionsforRemovingandInstallingtheHydraulic
SystemComponents(page6–145).
3.Locatethehydraulicliftcontrolmanifoldthatisattachedtotheframebracket
underthefrontplatform.
4.Forassemblypurposes,labelallthehydraulicconnections.Cleanthe
hydraulicconnectionsbeforelooseningthehydrauliclines.
Reelmaster
®
5410/5510/5610Series
Page6–195
HydraulicSystem:ServiceandRepairs
15216SLRevC