Toro reelmaster 5410 series - Page 312

ServicingtheMow/BacklapSpool(continued)
D.Pullthespoolupandoutofthemowmanifold.RemovetheO-ringsand
back-upringfromthespool.
E.DiscardtheO-ringsandback-upringsthatwereremoved.
2.Visuallyinspectthemanifoldportfordamagetothesealingsurfaces,
damagedthreads,andcontamination.
3.Installthemow/backlapspoolinthemowcontrolmanifoldasfollows:
A.InstalltheO-ringsandback-upringtotheuppergroovesonthespool.
ApplyalightcoatingofgreasetotheO-rings.
B.Carefullypushthespooldownintothemowmanifoldportuntilthelower
O-ringandback-upringgrooveisexposedatthebottomofthemanifold.
InstallthelowerO-ringandback-upringtothespool.Applyalight
coatingofgreasetotheO-ring.
C.Carefullyraisethemow/backlapspooluntiltheupperretainingring
grooveonthespoolisexposedonthetopofthemanifold.Installthe
upperretainingring.
D.Pushthemow/backlapspooldownandinstallthelowerretainingring
tothespool.
E.Ifthehandlewasremovedfromthespool,positionthespoolsothat
thehandlelocationofspoolisbetweenthestoppins.ApplyLoctite603
RetainingCompound(orequivalent)tothethreadsonthehandleand
installthehandleintothespool.T orquethehandleto13.6N∙m(10ft-lb).
F.Placetheballanddowelpininthebacklapswitchmanifoldport(Figure
165).InstallnewO-ringontothebacklapswitch.Threadthebacklap
switchintotheportandtorquetheswitchto27N∙m(20ft-lb).
HydraulicSystem:ServiceandRepairs
Page6–194
Reelmaster
®
5410/5510/5610Series
15216SLRevC