Toro reelmaster 5410 series - Page 321

RemovingtheCuttingReelMotor(continued)
3.Forassemblypurposes,labelallthehydraulicconnections.Cleanthe
hydraulicconnectionsbeforelooseningthehydrauliclinesfromthereel
motor.
CAUTION
Beforeopeningthehydraulicsystem,operateallthehydraulic
controlstoreleasesystempressureandavoidinjuryfromthe
pressurizedhydraulicuid;refertoReleasingPressurefromthe
HydraulicSystem(page6–8).
4.Disconnectthehydraulichosesfromthettingsinthereelmotor.Allowthe
linestodrainintoasuitablecontainer.RemoveanddiscardtheO-rings
fromthettings.
5.Installcleancapsorplugsonthehydraulichosesandttingstoprevent
systemcontamination.
6.Removethereelmotorfromthecuttingunit;refertoRemovingtheHydraulic
ReelMotor(page9–17).
7.Ifthehydraulicttingsaretoberemovedfromthemotor,markthetting
orientationforassemblypurposes.Removethettingsfromthemotorand
discardtheO-ringsfromthettings.
InstallingtheCuttingReelMotor
g214397
Figure172
1.Weightlocation2.Reelmotorlocation
Note:RefertoFigure172forcorrectplacementofcuttingunitreelmotorsand
weights.
1.Ifthehydraulicttingswereremovedfromthereelmotor,lubricateandinstall
newO-ringstothettings.Installthettingsintothemotorports;referto
InstallingtheHydraulicFittings(SAEStraightThreadO-RingFittinginto
theComponentPort)(page6–13).Ensurethatthettingsareorientated
correctly.
2.Installthereelmotortothecuttingunit;refertoInstallingtheHydraulicReel
Motor(page9–17).
3.Removethecapsorplugsfromthehydraulichosesandttings.
Reelmaster
®
5410/5510/5610Series
Page6–203
HydraulicSystem:ServiceandRepairs
15216SLRevC