Toro reelmaster 5410 series - Page 509

ServicingtheRearAxle(continued)
2.Cleantherearaxlebushingsandinspecttheaxlebushings(item7inFigure
300)forwearordamage.Ifthebushingsneedreplacement,dothefollowing
steps:
Note:Donotdamagetheboreoftheaxleduringbushingremoval.
A.Useabushingremovaltooltoextractboththeaxlebushingsfromthe
axlepivot.
B.Cleantheinsideoftheaxlepivottoremoveanydirtorunwantedmaterial.
C.Applygreasetotheinnerandoutersurfacesofnewaxlebushings.
D.Pressthenewaxlebushingsintotheaxlepivotboreuntilbushingis
ushwiththeaxle.
E.Afterbushinginstallation,ensurethatthepivotpinslideseasilyintothe
bushings.Ifthereisanybinding,locateandcorrectthesourceofbinding.
ServicingtheTieRodAssembly
g185939
Figure302
1.Balljoint(left-handthread)
3.Tierodgroove
5.Jamnut(right-hand
thread)
2.Jamnut(left-handthread)
4.Tierod
6.Balljoint(right-hand
thread)
Note:Thetierodballjointandjamnutatthegroovedendofthetierodhave
lefthandthreads.
1.Loosenthejamnutsandthenremovetheballjointsfromthetierod.
2.Threadnewballjointsequallyintothetierodsothattheballjointcenterto
centerlengthis920.5mm(36.240inches).
3.Cleanthetaperedsurfacesofthetierodballjointsbeforeyouinstallthetie
rodtothedraglinksontherearaxle.
InstallingtheRearAxle
Note:OnmachineswithCrossTraxAWD,donotdamagetheCrossTraxAWD
controlmanifoldorattachedhydraulictubesduringaxleinstallation.
1.Positiontherearaxleassemblytotheframe.Installthethrustwasher(item6
inFigure300)betweeneachsideoftheaxleandframe.Slidethepivotpin
throughtheframe,thrustwashers,andaxle.Ensurethattherollpinonthe
pivotpinispositionedintheframereliefs.
2.Installathrustwasher(item36inFigure300)andjamnutontothepivotpin.
Torquethejamnutto123to162N∙m(90to120ft-lb).Ensurethattherear
axlecanstillpivotfreelyafterthejamnutistightened.
Reelmaster
®
5410/5510/5610Series
Page8–21
Chassis:ServiceandRepairs
15216SLRevC