Toro reelmaster 5410 series - Page 579

AssemblingtheRoller(continued)
g195712
Figure354
1.Rollertube
4.Outerseal
2.Innerseal
5.Bearing/outersealtool
3.Bearing
C.Installtherstoutersealintotherollertubeandensurethattheseallip
(andgarterspring)facesendofthetube.Useabearing/outersealtool
andasoft-facedhammertolightlyseatsealagainsttherollershoulder;
referto(page).Ensurethatthebearingstillfreelyrotatesaftertheseal
installation.
D.Usethesameprocess,installthesecondoutersealandensurenotto
crushtheinstalledouterseal.Again,ensurethatthebearingstillfreely
rotates.
3.Fromtherollertubeendwithonlytheinnersealinstalled,carefullyinstallthe
rollershaftintotherollertube.Ensurethatthesealsarenotdamagedas
theshaftisinstalled.
4.Installthenewbearingandoutersealsintothesecondendoftheroller
tubeasfollows:
A.Positionasecondnewbearingtotherollershaftandtube.Positionthe
washeronthebearingtopressboththeinnerandouterbearingracesat
thesametime.
g252749
Figure355
1.Rollertube4.Bearing
2.Rollershaft
5.Washer
3.Innerseal
6.Bearing/outersealtool
B.Usethewasherandbearing/outersealtoolwithasoft-facedhammerto
fullyseatbearing;referto(page).Afterthebearinginstallation,ensure
thattheshaftfreelyrotatesandthatthereisnobinding.Ifnecessary,
lightlytapthebearingand/orshaftendstoaligntheshaftandbearings.
Removethewasherfromtheroller.
C.Applyasmallquantityofgreasearoundthelipofbothouterseals.
Reelmaster
®
5410/5510/5610Series
Page9–49
CuttingUnit:ServiceandRepairs
15216SLRevC