Toro Reelmaster 5510-D - Page 516

RemovingtheOperatorSeat(continued)
g185921
Figure309
1.Seatbase3.Bushing(2each)5.Flatwasher(2each)
2.Controlarm
4.Retainerbracket
6.Flange-headscrew(2
each)
5.Removethe2ange-headscrewsand2atwashersthatsecurethecontrol
armassemblytotheseatbase(Figure308andFigure309).
IMPORTANT
Donotdamagetheplatformwireharnesswhenremovingtheseat
andcontrolarmassemblyfromthemachine.
6.Carefullyslidethecontrolarmassemblyfromtheseatbase.Locateand
retrievethe2bushings(item3inFigure309).Positionandsupportthe
controlarmassemblytoallowseatremoval.
7.Removethe4socket-headscrews(item15inFigure307)and4atwashers
thatsecuretheseatandseatbasetotheseatadjusters.
8.Recordwhichsetofseatmountingholesareused,removetheoperatorseat
andseatbasefromtheseatadjusters.
InstallingtheOperatorSeat
1.Usethemountingholesthatwererecordedduringremoval,positiontheseat
andseatbasetotheseatadjusters.
2.Securetheseatandseatbasetotheseatadjusterswiththe4atwashers
and4socket-headscrews(item15inFigure307).
IMPORTANT
Donotdamagetheplatformwireharnesswheninstallingthecontrol
armassemblytothemachine.
3.Ensurethatthe2bushings(item3inFigure309)arepositionedinthecontrol
arm.Carefullyslidethecontrolarmassemblyontotheseatbasepost.
Securethecontrolarmassemblytotheseatbasewiththe2ange-head
screwsand2atwashers(Figure308andFigure309).
Chassis:ServiceandRepairs
Page8–28
Reelmaster
®
5410/5510/5610Series
15216SLRevC