Toro Workman 07390 - Page 51

3.Removethe6hex-washerscrews(#10x3/4
inch)thatsecurethecontrol-coverplatetothe
seatbase,andremovethecoverplate(Figure
60).
4.Movethespeed-rangelevertotheT
(TRANSPORT)position(Figure62).
5.Loosenthe2hex-socketscrews(5/16x3/4inch)
thatsecurethedetentplatetothelever-support
bracket(Figure62).
g025550
Figure62
1.Lever-supportbracket3.Detentplate
2.Hex-socketscrews
6.Movethedetentplateinoneofthefollowing
directions:
•Movethedetentplateforwardtoincrease
themaximumgroundspeedlimit(Figure62).
•Movethedetentplaterearwardtodecrease
themaximumgroundspeedlimit(Figure62).
7.Tightenthe2hex-socketscrews(5/16x3/4
inch)to19.8to25.4N∙m(14.6to18.7ft-lb).
8.Drivethemachinewiththespeedcontrolset
tospeedrangeforwhichyouaresettingthe
maximumgroundspeedlimit.Ifthemaximum
groundspeedlimitistoofastortooslow,repeat
steps1through8untilthecorrectmaximum
groundspeedlimitisattained.
9.Aligntheholesinthecontrol-coverplatetothe
holesintheseatbase(Figure60).
10.Securetheplatetothebasewiththe6
hex-washerscrews(Figure60)thatyou
removedinstep3.
11.Threadtheknobsontotherodsforthe
hydraulic-liftleverandthespeed-rangelever
(Figure60).
CheckingtheDriveBelt
ServiceInterval:Every400hours
1.Removethe9hex-washerbolts(1/4x1inch)
thatsecurethetransmissioncovertothe
mountingplateofthetransmission(Figure63).
g025548
Figure63
1.Hex-washerbolts(1/4x1
inch)
4.Mountingplate
2.Transmissioncover
5.Taperedfaces(primary
clutch)
3.Drivebelt6.Beltwidth—replaceat
29.5mm(1.16inches)or
less
2.Movethecoverforwarduntilyoucanseethe
drivebelt(Figure63).
3.Checkthetaperedfacesoftheprimaryclutch
forsignsifdamage(Figure63).
Note:Ifthefacesoftheprimaryclutchare
damaged,replacetheprimaryclutch;contact
yourAuthorizedServiceDealer.
4.Checkthedrivebeltformissingordamaged
cogs(Figure63).
Note:Ifthecogsofthedrivebeltaremissingor
damaged,replacethedrivebelt.
5.Measureacrossthebeltandrecordthebelt
width(Figure63).
Note:Ifthewidthofthebeltis29.5mm(1.16
inches)orless,replacethebelt(Figure63).
6.Aligntheholesinthetransmissioncoverwith
theholesinthemountingplate(Figure63).
7.Securethecovertothemountingplate(Figure
63)withthe9hex-washerbolts(1/4x1inch)
51