Toro Workman 07390 - Page 60

g024249
Figure79
Hydraulic-uidlevel(non-TCmodels)
1.Cap
2.Dipstick3.Fillerneck
g024250
Figure80
Hydraulic-uidlevel(non-TCmodelwiththeHighFlow
HydraulicKit(optionalkit)orTCmodel)
1.Cap
2.Dipstick3.Fillerneck
5.Removethecapanddipstickfromthellerneck
ofthereservoirandwipethedipstickcleanwith
arag(Figure79andFigure80).
6.Insertthedipstickintothellerneck;then
removeitandchecktheuidlevel(Figure79
andFigure80).
•Non-TCmodel:Thehydraulic-uidlevel
shouldbebetweenthelowerindentedarea
onthedipstick.
•Non-TCmodelwiththe
High-Flow-HydraulicKit(option)or
TCmodel:Thehydraulic-uidlevelshould
bebetweentheupperindentedareaonthe
dipstick.
7.Ifthelevelislow,addthespeciedhydraulic
uidintothereservoirtoraisetheleveltothe
middleoftheindentedareaonthedipstick
(Figure79andFigure80).
8.Installthedipstickandcaptothellerneckof
thereservoir(Figure79andFigure80).
60