12
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
TRANSFER/TRANSPORT UNIT
12 - 13
[J] Transfer belt contact/release cam driving unit
[K] Transfer belt cam motor (M15)
(1) Take off the rear cover.
( P.2-45 "[L] Rear cover")
(2) Remove 3 screws to take off the flywheel.
(3) Disconnect 1 connector and remove 2
screws to take off the cam driving unit.
Fig. 12-26
(4) Remove 1 screw to take off the transfer belt
release detection sensor (S15).
(5) Remove 1 screw to take off the transfer belt
contact detection sensor (S16).
Fig. 12-27
(1) Take off the transfer belt contact/release cam
driving unit.
( P.12-13 "[J] Transfer belt contact/release
cam driving unit")
(2) Remove 2 screws and disconnect 1
connector to take off the transfer belt cam
motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 12-28
Transfer belt contact/release cam drive unit
Screw
Transfer belt release
detection sensor
Transfer belt contact
detection sensor
Transfer belt cam motor
To Next Page
Loading...
